7.
Close the expansion card retention clamp by rotating it downward.
●
If the PCI retention clamp does not close, ensure that all cards are properly seated, and then
try again.
●
If required by the card, connect the auxiliary power cable to the card (not illustrated).
8.
Install the card hold-down if it is provided with your card and if the side access panel does not
already have one:
a.
Remove the protective strip from the adhesive strip on the bottom of the hold-down (1).
b.
Carefully place the hold-down on the inside of the side access panel:
●
Align the hold down with the edge of the hood label and the edge of the side access
panel (2).
●
Make sure the overhanging tab on the hold down faces toward the center of the side
access panel with the foam padding facing up.
Figure 5-77
Installing the card hold-down
9.
Replace the access panel (see
Installing the access panel on page 72
).
10.
Restore all connections and equipment that you removed during the
Predisassembly procedures
on page 69
.
130
Chapter 5 Replacing components
ENWW
Содержание Z200 - Small Form Factor Workstation
Страница 1: ...HP Z200 Small Form Factor Workstation Maintenance and Service Guide ...
Страница 4: ...iv About this guide ENWW ...
Страница 12: ...xii ENWW ...
