17
printing a print server configuration page
1.
Turn on the printer.
2.
Press and hold the
Test
button on the
back of the print server until the Power
and Status lights begin blinking.
3.
Release the
Test
button to print a Print
Server Configuration Page.
Printing a Print Server Configuration
Page verifies that the print server and
printer are communicating properly. If
the Print Server Configuration Page does
not print:
1.
Verify the following:
–
power and parallel cables are
firmly connected
–
printer is turned on
–
PCMCIA card is securely installed
2.
Print a Print Server Configuration
Page.
3.
If a Print Server Configuration Page
does not print, see page 19.
Shown below is a print server’s default
settings.
*********************** Print Server Configuration ***********************
Mac Address
: 00C06F0396D3
FLASH-ROM Version
: 0035
Build Date
: 2001-07-16
BOOT-ROM
Version
: 0090
Build Date
: 2001-05-17
1. TCP/IP settings
IP Address
: 192.168.2.200
Subnet mask
: 255.255.248.0
Default Gateway
: 192.168.2.1
RARP
: Disable
BOOTP
: Disable
DHCP
: Disable
ARP + PING
: Enable
2. AppleTlak Settings
Status
: Enable
Printer
: npi0396D3.LaserJet 1220
Zone
: (default zone)
3. SNMP settings
Set Communicty Name
: (set)
4. Wireless settings
Connection Mode
: Infrastructure
WEP Request
: 40Bit Enable(Shared Key)
SSID
: iIPS-TM
Fragmentation Thresh. : 2346
RTS Threshold
: 0
Tx Rate
: Auto
Country Code
: 2
5. Current Status
Connection Status
: Connected(Infrastructure)
Link Status
: Good
Current Channel
: 3
Parallel Port Mode
: ECP Mode
Printer Manufacturer
: Hewlett-Packard
Printer Model
: HP LaserJet 1220
6. Network Statistics
Unicast Packets Rcvd. : 3
Total Packets Rcvd.
: 92
Packets Transmitted
: 29
****************************************************************************
END OF PRINTOUT