WARNING: When using this device, basic safety
precautions should always be followed to reduce
the risk of fire, electric shock, and injury to
persons, including the following:
•
Do not use this product near water, for
example, near a bathtub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or
near a swimming pool.
•
Avoid using this product during an electrical
storm. There may be a remote risk of electric
shock from lightning.
•
Do not use this product to report a gas leak in
the vicinity of the leak.
•
Always disconnect the modem cable before
opening the equipment enclosure or touching
an uninsulated modem cable, jack, or internal
components.
•
If this product was not provided with a
telephone line cord, use only No. 26 AWG or
larger telecommunication line cord in order to
reduce the risk of fire.
•
Do not plug a modem or telephone cable into
the Network Interface Card (NIC) receptacle.
SAVE THESE INSTRUCTIONS
DOC Statement (Canada Only)
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
Additional Safety Information
This product has not been evaluated for connection to an “IT”
power system (an AC distribution system with no direct
connection to earth, according to IEC 60950).
This equipment meets the applicable Industry Canada Terminal
Equipment Technical Specifications. This is confirmed by the
registration number. The abbreviation, IC, before the
registration number signifies that registration was performed
based on a Declaration of Conformity indicating that Industry
Canada technical specifications were met. It does not imply
that Industry Canada approved the equipment.
AC Power Safety Warning
WARNING: Install the computer near an AC
outlet. The AC power cord is your computer’s
main AC disconnecting device and must be easily
accessible at all times. For your safety, the
power cord provided with your computer has a
grounded plug. Always use the power cord with
a properly grounded wall outlet, to avoid the
risk of electrical shock.
WARNING: Your computer is provided with a
voltage select switch for use in a 115 or 230 V
∿
power system. The voltage select switch has been
pre-set to the correct voltage setting for use in the
particular country/region where it was initially
sold. Changing the voltage select switch to the
incorrect position can damage your computer and
void any implied warranty.
WARNING: To reduce the possibility of an electric
shock from the telephone network, plug your
computer into the AC outlet before connecting it to
the telephone line. Also, disconnect the telephone
line before unplugging your computer from the
AC power outlet.
WARNING: Always disconnect the modem cord
from the telephone system before installing or
removing your computer cover.
WARNING: Do not operate the computer with the
cover removed.
WARNING: For your safety, always unplug the
computer from its power source and from any
telecommunications systems (such as telephone
lines), networks, or modems before performing
any service procedures. Failure to do so may
result in personal injury or equipment damage.
Hazardous voltage levels are inside the power
supply and modem of this product.
Lithium Battery Caution
WARNING: The computer uses a lithium battery,
type CR2032. There is danger of an explosion if
the battery is incorrectly replaced. Replace only
with the same, or equivalent, type recommended
by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
Laser Safety Statement
Class 1 LED Product
The CD and DVD drives contain a laser system and are
classified as a “Class 1 Laser Product” under a
U.S. Department of Health and Human Services (DHHS)
Radiation Performance standard according to the Radiation
Control for Health and Safety Act of 1968.
Should the unit ever require maintenance, contact an
authorized service location.
WARNING: Use of controls, adjustments, or
performance procedures other than those
specified in the
Upgrading and Servicing Guide
may result in hazardous radiation exposure. To
prevent direct exposure to laser beam, do not try
to open the enclosure of the CD or DVD drives.
Laser Product Label
The following label or equivalent is located on the surface of
laser products:
This label indicates that the
product is classified as a CLASS 1
LASER PRODUCT. This label
appears on a laser device
installed in your product.
16