HP Surestore FC10 - Disk Array, Руководство по обслуживанию

Страница: 99 / 164

,VRODWLQJ&DXVHV
99
T
rouble
sho
o
ting
Isolating Causes
7DEOHOLVWVWKHSUREDEOHFDXVHVDQGVROXWLRQVIRUSUREOHPV\RXPD\GHWHFWRQ
WKHGLVNV\VWHP:KHQPRUHWKDQRQHSUREOHPDSSOLHVWR\RXUVLWXDWLRQLQYHVWLJDWH
WKHILUVWGHVFULSWLRQWKDWDSSOLHV7KHWDEOHOLVWVWKHPRVWEDVLFSUREOHPVILUVWDQG
H[FOXGHVWKHPIURPVXEVHTXHQWSUREOHPGHVFULSWLRQV
7DEOH 7URXEOHVKRRWLQJ7DEOH
Problem
Description HWEvent
Category LED
State
Status
Probable Cause/Solution SAM STM
Installed disk
system does
not power on none System
power
LED off none none – Neither power cord is plugged in.
– The power switch is not pressed.
– AC breaker is tripped.
– AC power source has failed.
– The PDU/PDRU is defective.
– Power switch is defective.
– A faulty component is causing power
supplies to turn off. Remove all
components and reinsert one at a
time until the faulty component is
isolated.
Installed disk
system beeps
when
powered on none System
fault &
both
LCC
Fault
LEDs on none none Enclosure IDs on peer LCCs do not
match. Determine the correct Enclosure
ID and reset the ID on one or both
LCCs. Reinsert the LCC(s) with the
changed ID.
System fault
LED is on none Power
supply
LED off Power
supply Not
Available Power
supply
Not
Available – The power supply is not plugged in.
– The PDU/PDRU or primary power
source has failed.
Critical Part fault
LED on Critical Critical A component has failed. See problem
descriptions below.