3.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
If the WLAN antenna is not connected to the terminal on the WLAN module, a protective sleeve must
be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
28
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Содержание Stream 14
Страница 4: ...iv Safety warning notice ...
Страница 8: ...viii ...
Страница 39: ...Reverse this procedure to install the heat sink Component replacement procedures 31 ...