HP StorageWorks SR2122, Руководство пользователя

Страница: 29 / 242

Installation
29 IP Storage Router SR2122-2 User Guide
Installing on a Table or a Shelf
You can install the storage router on a table or a shelf (or another flat, secure
surface).
If you are going to install the storage router in an equipment rack, skip this section
and proceed to the “
Rack-Mounting the Storage Router ” section. To install the
chassis on a table or a shelf:
1. Locate the four adhesive-backed rubber feet in the accessory kit that is
shipped with the storage router.
2. Peel the rubber feet from their backing and place the feet onto the four round
recessed areas on the bottom of the chassis.
3. Place the storage router on a table or a shelf near an AC power source.
Rack-Mounting the Storage Router
You can rack-mount the SR2122-2 in a 19-inch equipment rack with the front
panel forward.
The accessory kit shipped with your storage router contains:
■ two rails
■ two wing nuts
■ various screws
You need the following tools to install the SR2122-2 in a rack:
■ Phillips screwdriver
■ Tape measure
To install the SR2122-2 in a rack:
1. Prepare for installation:
a. Place the storage router on the floor or on a sturdy table as close as
possible to the rack. Leave enough clearance so that you can move around
the storage router.
b. Use a tape measure to measure the depth of the rack. Measure from the
outside of the front mounting uprights to the outside of the rear mounting
uprights. The depth must be at least 19 inches (48.26 cm) but not more
than 32 inches (81.3 cm).