HP StorageWorks DAT 40i, Руководство по началу работы, Страница: 19 / 50

15
Step 3: Prepare the mounting bay
Warning
To avoid personal injury or damage to the server or tape drive, ensure that the server is
disconnected from the mains power supply while you install the drive.
Caution
Static electricity can damage electronic components. Always wear an antistatic wriststrap if
one is available. If not, after you have disconnected power from the server and removed the
cover, touch a bare metal part of the chassis. Similarly, touch a bare metal part of the drive
before installing it.
1 Assemble the necessary tools and materials:
• Phillips screwdriver
Flat-bladed screwdriver (if your server uses slotted screws)
• Torx screwdriver (if your server uses torx screws)
• Your server manuals (for reference during installation)
2 Perform a normal system shutdown and turn off the server and any connected peripherals.
3 Remove the cover and front panel from the server, as detailed in your server’s documentation.
As you work inside the server, you may have to disconnect the SCSI cable or power cable
from other devices to maneuver the new drive into place. If you have to do this, make a note
of their position and connections so you can put them back correctly later.
4 Remove the filler panel from a spare 5¼-inch bay of your server, as described in your server’s
documentation. Keep any screws for use in “Step 7: Secure the drive” on page 23.
dds-internal-frame6.fm Page 15 Monday, January 5, 2004 5:01 PM