HP StorageWorks 8B - FC Entry Switch, Справочное руководство

Страница: 291 / 342

Fabric OS Reference 1-277
Telnet Commands
1
uRouteConfig
Configure a static route.
Synopsis
uRouteConfig port, domain, outputport
Availability admin
Description Use this command to configure static routes. A static route is assigned a specific path; the path does
not change with a topology change unless the path becomes unavailable.
After this command is issued, and if
outputport
is a usable port, all frames coming in from a
specified
port
addressed to the specified
domain
are routed through the specified
outputport
.
If
outputport
is not usable, the routing assignment is not affected. When
outputport
becomes usable the static route assignment for the
port
is enforced.
outputport
is usable if the associated neighbor associated is in
NB_ST_FULL
state. See
interfaceShow for more information.
Using static routes can affect load sharing. If a large number of routes are statically configured to
the same output port, the ability of the switch to achieve optimum load sharing may be impaired.
To prevent routing loops, static route configuration using a non-minimum cost path is not allowed.
If you attempt to configure such a route, you are asked if the entry should be saved in the database.
Operands This command has the following operands:
port
Specify the port to be statically routed; can be either an
F_port
or an
E_port
.
Valid values for port number vary depending on the switch type. This operand is
required.
domain
Specify the destination domain. This operand is required.
outputport
Specify the output port where traffic is to be forwarded. This operand is required.
Examples To configures a static route for all traffic coming in from port 1 and addressed to domain 2 to go
through port 5:
See Also
configShow
interfaceShow
uRouteRemove
uRouteShow
switch:admin> uRouteConfig 1,2,5
The configuration will now contain the static route:
switch:admin> configShow "route"
route.ucastRoute.1.2: 5
route.ucastRouteCount: 1