Hardware options installation 47
General DIMM slot population guidelines
•
The server supports two memory channels with two DIMM slots per channel:
o
Memory channel 1 consists of the two DIMMs that are closest to the processor.
o
Memory channel 2 consists of the two DIMMs that are located farthest from the processor.
•
White DIMM slots denote the first slot of a channel (3-A, 1-B).
•
The server supports up to 32 GB of system memory using four 8 GB 1600 MT/s ECC UDIMMs.
•
When installing DIMMs:
o
Populate the DIMM slots in this sequence: 3-A, 1-B, 4-C, 2-D.
o
Use only HP qualified DIMMs.
•
The server does not support RDIMMs and LRDIMMs.
•
The minimum DIMM requirement to make this server bootable is a DIMM in slot 3-A.
•
For DIMM spare replacement, install the DIMMs per slot number as instructed by the system software.
For detailed memory configuration rules and guidelines, use the Online DDR3 Memory Configuration Tool
on the HP website (
http://www.hp.com/go/ddr3memory-configurator
).
Installing a DIMM
1.
Power down the server (on page
14
).
2.
Remove the power from the server:
a.
Disconnect the power cord from the power source.
b.
Disconnect the power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
14
).
o
Remove the server from the rack (on page
16
).
4.
Remove the access panel (on page
17
).
5.
Remove the air baffle (on page
18
).
6.
Open the DIMM slot latches.
Содержание ProLiant DL320e Gen8 v2
Страница 65: ...Cabling 65 Front I O board cabling ...
Страница 94: ...Support and other resources 94 ...
Страница 95: ...Support and other resources 95 ...
