Removing and installing the optional front bezel dust filter
Some models are equipped with an optional front bezel dust filter. You must periodically clean the dust filter
so that the dust collected on the filter does not impede air flow through the computer.
NOTE:
The optional front bezel dust filter is available from HP.
To remove, clean, and replace the dust filter:
1.
Turn off the computer properly through the operating system, and turn off any external devices.
2.
Disconnect the power cord from the AC outlet and disconnect any external devices.
NOTE:
Regardless of the power-on state, voltage is always present on the system board as long as the
system is plugged into an active AC outlet. To prevent damage to internal components, you must
disconnect the power cord from the power source before opening the computer.
3.
To remove the dust filter, use your fingers to separate the filter from the front bezel at the tab locations
shown below.
4.
Use a soft brush or cloth to clean dust from the filter. If heavily soiled, rinse the filter clean with water.
10
Chapter 2 Hardware upgrades
Содержание ProDesk 600 G3 SFF Business PC
Страница 1: ...Hardware Reference Guide HP ProDesk 600 G3 SFF Business PC ...
Страница 4: ...iv About This Book ...
