14
Installation Instructions
Ceiling Mount Hardware
■
Light pipe extender
■
Badge for light pipe extender
■
Label for light pipe badge
■
Safety wire (recommended) and security cable (optional)
Ceiling Mount Procedure
1.
If possible, remove the ceiling tile from its frame and place it, finished side
down, on a work surface.
2.
Mark a point on the upper or unfinished side of the tile where the light
pipe extender will be installed. It is best to leave at least 5 cm (2 in.) or
more between the edge of the ceiling tile and the center of the light pipe
to allow clearance for placement of the Radio Port and antenna connec-
tions above the ceiling tile.
3.
Drill two 6 mm (1/4 inch) holes adjacent to each other through the ceiling
tile to accommodate the twin shafts of the light pipe extender.
4.
Snap the clips of the light pipe extender into the bottom of the Radio Port
case.
5.
Place the Radio Port and light pipe extender over the hole on the unfin-
ished side of the ceiling tile . Fit the light pipe extender through the hole
to project through on the finished side of the ceiling tile.
6.
Place the label for the light pipe badge over the hub on the back of the
badge and press the badge onto the light pipe extender from the finished
side of the ceiling tile.
7.
If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm
(.10in.) in diameter, to a secure, stationary point in the ceiling space.
8.
If required, attach a security cable to a secure, stationary point in the
ceiling space.
9.
Attach the appropriate antennas to the Radio Port's antenna connectors.
If the antennas are intended to be mounted below the ceiling tile, it may
be convenient to make provision for this installation in the same ceiling
tile as the Radio Port and light pipe extender.
10. Bring the ceiling tile into the ceiling space.
11. Attach the end of the safety wire from Step 7. to the safety wire tie point
on the Radio Port.
