12
Installation Instructions
2.
For a horizontal Radio Port installation, lightly mark a horizontal line on
the wall at the location where the midline of the Radio Port is to be located.
For a vertical installation, lightly mark a vertical line on the wall at the
location where the midline of the Radio Port is to be located.
3.
Using the alignment arrows on one edge of the Radio Port case as guides,
place the edge of the Radio Port along the midline from step 1. and mark
the two points on the midline for the location of the mounting screws.
4.
At each of the two points, drill a hole in the wall, insert an anchor (if
required), screw the wall mounting screw into the anchor and stop when
there is 1mm remaining between the screw head and the wall.
N o t e
When pre-drilling holes, the recommended hole size is 3mm (0.125 or 1/8 in.)
if the screws are going directly into the wall and 6mm (0.25 or 1/4 in.) if the
provided wall anchors are being used.
5.
If required, loop a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.)
in diameter, around the safety wire tie post on the Radio Port and secure
the loop. Attach the opposite end of the safety wire to a secure point on
the wall.
6.
If required, install and attach a security cable to the Radio Port's lock port.
The lock port, compatible with laptop-style security cables, is on the side
of the case. Attach the opposite end of the security cable to a secure,
stationary point.
7.
Attach the appropriate antennas to the Radio Port's antenna connectors.
Pay close attention to ensure that the appropriate antenna for each
frequency band is attached to the appropriate antenna connector for that
frequency band on the Radio Port. For single (non-diversity) antennas,
attach the antenna to the Radio Port connector marked as Primary for
that frequency band.
8.
Plug the Ethernet cable into the Radio Port's RJ-45 port and connect the
opposite end of the cable to a switch with an 802.3af-compatible power
source.
9.
Place the large corner of each of the case's mounting slots over the
mounting screw heads.
10. Slide the case down along the mounting surface to hang the Radio Port
mounting slots on the mounting screw heads.
11. Verify the unit has power by observing that the LEDs are lit or flashing.
