7
Wall mounting consists of hanging the ProCurve Radio Port 230 or 210 along its width or length using the pair of wide-
shoulder screws provided and mounting slots on the underside of the Radio Port. The ProCurve Radio Port 230 or 210
can be mounted onto any wood, plaster, or cement wall surface using the provided wall anchors when necessary. The
illustration shows a horizontal mount.
Wall Mount Hardware
• Two wide-shoulder Phillips pan head self-tapping screws.
• Two wall anchors.
• Safety wire (recommended) and security cable (optional)
In the event that the original mounting screws are lost, the following screws can be used instead: ANSI Standard)
#6-18 X 0.875in. Type A or AB Self-Tapping Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D Self-
Tapping Screw.
Wall Mount Procedure
1. Lightly mark a vertical line on the wall at the location where the midline of the Radio Port is to be located.
2. Using the alignment arrows on one edge of the Radio Port case as guides, move the edge of the Radio Port to the
midline from step 1. and mark the two points on the midline for the location of the mounting screws. (See diagrams
below)
3. At each of the two points, drill a hole in the wall, insert an anchor (if required), screw the wall mounting screw
into the anchor and stop when there is 2 mm remaining between the screw head and the wall
Note: When pre-drilling holes, the recommended hole size is 3mm (0.125 or 1/8 in.) if the screws are going directly
into the wall and 6mm (0.25 or 1/4 in.) if the provided wall anchors are being used.
4. If required, loop a safety wire, between 1.0 mm (.04in.) and 1.6 mm (.0625in.) in diameter, through the safety wire
tie point and secure the loop. Attach the opposite end of the safety wire to a secure point on the wall.
5. If required, install and attach a security cable to the Radio Port's lock port. The lock port, compatible with laptop-
style security cables, is on the side of the case. Attach the opposite end of the security cable to a secure, stationary
point.
6. Plug the Ethernet cable to the Radio Port's RJ-45 port and connect the opposite end of the cable to a switch with
an 802.3af compatible power source. The Ethernet cable can be tucked inside the cable recess on the underside
of the Radio Port case for a completely clean installation. See diagram below.
7. Place the middle of each of the case's mounting slots over the mounting screw heads.
8. Slide the case down along the mounting surface to hang the mounting slots on the mounting screws.
9. Verify the Radio Port has power by observing that the LED indicators are lit or flashing.
