3.
Connect the power cable
(1)
and data cable
(2)
to the back of the hard drive.
Figure 6-31
Connecting the Hard Drive Cables
CAUTION:
Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A
sharp bend can break the internal wires.
4.
Place the hard disk drive cage into the chassis
(1)
, then slide it down toward the bottom of the
chassis until it locks into place
(2)
.
Figure 6-32
Installing the Hard Drive Cage
62
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
