Installing an Internal 3.5-inch Hard Drive
1.
Follow the steps in
Removing an Internal 3.5-inch Hard Drive on page 113
to remove the old
hard drive.
2.
Install the guide screw in the middle hole on the right side of the drive.
NOTE:
When replacing a hard drive, remove the guide screws from the old drive for use with
the new drive.
Figure 7-36
Installing the Guide Screw in the Hard Drive
3.
Align the guide screw on the drive with the slot on the chassis. Slide the hard drive into the drive
bay from the back until the two screw holes on the left side of the drive line up with the two
screw holes on the left side of the drive cage
(1)
.
4.
Secure the hard drive by fastening two retainer screws through the holes in the left side of the
drive cage into the corresponding holes in the left side of the hard drive
(2)
.
Figure 7-37
Installing an Internal Hard Drive
NOTE:
Extra retainer screws are provided on the front of the chassis under the hard drive
cage. The 6-32 retainer screws for hard drives are silver.
Drives 115
Содержание Pro 3000 MT
