418
•
The function of dropping unknown IPv6 multicast data is not enabled, so unknown IPv6 multicast
data is flooded.
Solution
1.
Use the
display acl ipv6
command to check the configured IPv6 ACL rule. Make sure the IPv6 ACL
rule conforms to the IPv6 multicast group policy to be implemented.
2.
Use the
display this
command in MLD-snooping view or the corresponding interface view to verify
that the correct IPv6 multicast group policy has been applied. If not, use the
group-policy
or
mld-snooping group-policy
command to apply the correct IPv6 multicast group policy.
3.
Use the
display current-configuration
command to verify that the function of dropping unknown
IPv6 multicast data is enabled. If not, use the
drop-unknown
or
mld-snooping drop-unknown
command to enable dropping unknown IPv6 multicast data.
Appendix
Processing of IPv6 multicast protocol messages
With Layer 3 multicast routing enabled, an MLD snooping-enabled switch processes IPv6 multicast
protocol messages differently under different conditions, as follows:
•
If only MLD is enabled on the switch, or if both MLD and IPv6 PIM are enabled on the switch, the
switch does the following:
{
Maintains dynamic member ports or dynamic router ports according to MLD packets
{
Maintains dynamic router ports according to IPv6 PIM hello packets
•
If only IPv6 PIM is enabled on the switch, the following occurs:
{
The switch broadcasts MLD messages as unknown messages in the VLAN.
{
After receiving an IPv6 PIM hello message, the switch maintains the corresponding dynamic
router port.
•
If MLD is disabled on the switch, one of the following occurs:
{
If IPv6 PIM is disabled, the switch deletes all its dynamic member ports and dynamic router
ports.
{
If IPv6 PIM is enabled, the switch deletes only its dynamic member ports but not its dynamic
router ports.
NOTE:
On a switch with Layer 3 IPv6 multicast routing enabled, use the
display mld group port-info
command
to display Layer 2 port information.
•
If IPv6 PIM is disabled on the switch, one of the following occurs:
{
If MLD is disabled, the switch deletes all its dynamic router ports.
{
If MLD is enabled, the switch maintains all its dynamic member ports and dynamic router ports.
