2.
Locate the two bracket bolts (1), the two lock
washers (2), and the four flat washers (3, 5).
a.
Onto each bracket bolt (1), thread a lock
washer (2) followed by a flat washer (3).
b.
Push both washers against the bracket bolt
(1) head.
3.
Place the AP on a table with the bracket posts (6)
pointing upwards.
4.
Position the bracket (4) over the bracket posts (6)
so that the holes in the bracket (4) and the bracket
posts (6) align.
5.
On one side of the AP, slide in a second flat
washer (5) between the bracket (4) and the
bracket post (6), and while holding the edge of
this flat washer (5), thread the bracket bolt (1)
[with the lock washer (2) and flat washer (3)
already threaded] through the hole in the bracket
(4), through the second flat washer (5), and then
screw the bracket bolt (1) sufficiently into the
bracket post (6) so that the threads fully grip.
6.
Repeat
Step 2
through
Step 5
for the second
bracket bolt (1).
The AP with attached bracket should now look
similar to
Figure 5 (page 4)
.
7.
Hold the AP with the Ethernet connector pointing
down near where you want to install it on the
pole, and press the pole cut out (9) against the
pole.
8.
See
Figure 6 (page 5)
. Wrap the first pole clamp
(4) around the pole (5), feed it through one pole
clamp slot (3) and then back out the other pole
clamp slot (3), and then around the pole (5), and
into the pole clamp anchor.
Hold the AP firmly in position against the pole
(5), and then fully tighten the pole clamp screw
to anchor the AP against the pole (5). Attach the
second pole clamp (4) in the same manner as the
first, also firmly tightening it.
9.
Rotate the AP body up or down to the wanted
position, and then tighten the bracket bolts to 50
kgf-cm (43.4 lbf-in).
Figure 6 AP mounted on pole
1
2
5
3
4
4
5. Pole
3. Pole clamp slot (x4)
1. Bracket post
4. Pole clamp (x2)
2. Bracket
Wall installation
IMPORTANT
: This procedure requires two people.
1.
Hold the mounting bracket as a drilling template
against the wall where you want to install it, with
the two bracket bolt holes (4) facing the left and
right sides. See
Figure 4 (page 4)
.
Using the four screw holes on the bracket (1),
mark four holes for the screws (wall anchors).
2.
Drill four holes for the wall anchors, 4.7 mm
(3/16 inch) in diameter.
3.
Insert the anchors and tap them flush with the wall
surface.
4.
Fasten the AP bracket to the wall with the
provided screws.
5.
Locate the two bracket bolts (1), the two lock
washers (2), and the four flat washers (3, 5). See
Figure 5 (page 4)
.
a.
Onto each bracket bolt (1), thread a lock
washer (2) followed by a flat washer (3).
b.
Push both washers against the bracket bolt
(1) head.
6.
Hold the AP up to the mounting bracket (4),
angling the AP so that it is parallel with the
mounting bracket (4), and the bolt holes align.
7.
Have an assistant hold the AP in place with the
bolt holes aligned. On one side of the AP, slide
in a second flat washer (5) between the bracket
(4) and the bracket post (6), and while holding
Page 5
