Figure 5 Mounting Bracket Attached
1
8
8
7
9
3
2
4
1
1
6
6
6
4
4
5
7
7. Screw hole (x4)
4. Bracket
1. Bracket bolt (x2)
8. Pole clamp slot (x4)
5. Flat washer (x2)
2. Lock washer (x2)
9. Pole cut out
6. Bracket post (x2)
3. Flat washer (x2)
3.
Locate the two bracket bolts (1), the two lock washers (2), and the four flat washers (3, 5).
Onto each bracket bolt (1), thread a lock washer (2) followed by a flat washer (3). Push both
washers against the bracket bolt (1) head.
4.
Place the AP on a table with the bracket posts (6) pointing upwards.
5.
Position the bracket (4) over the bracket posts (6) so that the holes in the bracket (4) and the
bracket posts (6) align.
6.
On one side of the AP, slide in a second flat washer (5) between the bracket (4) and the
bracket post (6), and while holding the edge of this flat washer (5), thread the bracket bolt
(1) (with the lock washer (2) and flat washer (3) already threaded) through the hole in the
bracket (4), through the second flat washer (5), and then screw the bracket bolt (1) sufficiently
into the bracket post (6) so that the threads fully grip.
7.
Repeat steps 3 through 6 above for the second bracket bolt (1). The AP with attached bracket
should now look similar to Figure 5.
8.
Hold the AP with the Ethernet connector pointing toward the ground near the desired position
on the pole and press the pole cut out (9) against the pole.
9.
Refer to Figure 6. For the first pole clamp (4), wrap the pole clamp (4) around the pole (5),
feed it through one pole clamp slot (3) and then back out the other pole clamp slot (3), and
then around the pole (5), and into the pole clamp anchor. Hold the AP firmly against the pole
10
Installing
