Cabling the HP Moonshot System 36
Cabling the HP Moonshot System
Cabling overview
WARNING:
To reduce the risk of electric shock or injury due to high-current electrical energy, be
sure that all power is completely disconnected at the source before beginning any power
connections to the power bus bars or power bus box.
WARNING:
Be sure that all circuit breakers are locked in the off position before connecting any
power components.
CAUTION:
To avoid damaging the fiber cables, do not drape cables from one side of the rack
to the other and do not run cables over a hard corner or edge.
After the hardware is installed, complete the following cabling procedures:
1.
Connect the Moonshot System to a network ("
Connecting the Moonshot System to a network
" on page
2.
Connect power cables to the chassis ("
Connecting power cables and applying power to the chassis
" on
3.
Route cables on the cable management arm ("
Routing cables on the cable management arm
" on page
Connecting the Moonshot System to a network
Connect the Moonshot System to the following networks:
•
Data center management network (on page
•
Data center production network (on page
Data center management network
To connect the chassis to a management network, connect an Ethernet cable from the Moonshot 1500 CM
module to the management network. Always connect to the iLO CM management port first. Do not connect
both the iLO CM management port and the iLO CM link port to the same network switch. For information
about enabling the iLO link port using the
set network daisy
command, see the
HP Moonshot iLO
Chassis Management CLI User Guide
in the HP Moonshot Information Library