HP J4897A, Руководство по установке

Страница: 21 / 60

2-5
Installing the Series 2700 Switches
Installation Procedures
In
st
a
lli
n
g
t
h
e S
e
ries 2700
Sw
it
c
h
es
2. Verify the Switch Operates Correctly
Before mounting the switch in its network location, you should first check
that it is working properly by plugging it into a power source and verifying
that it passes its self test.
1. Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a nearby properly grounded
electrical outlet.
N o t e
The Series 2700 Switches do not have a power switch. They are powered on
when the power cord is connected to the switch and to a power source. For
safety, the power outlet should be located near the switch installation.
The switch automatically adjusts to any voltage between 100-240 volts and
either 50 or 60 Hz. There are no voltage range settings required.
If your switch requires a different power cord than the one supplied with the
switch, please see the Installation Precautions on page 2-3.
2. Check the LEDs on the switch. The LED behavior is described on the next
page.
Line: 50/60 Hz.
100-240 V~ 1.5 A (1, 5 A)
Connect power cord to
the power connector
z3.book Page 5 Friday, November 1, 2002 5:40 PM