3.
Slide the memory carrier assembly cover toward the left side of the server to free it from the
center of the chassis. Lift the cover off the chassis (
).
Figure 2 Removing and Replacing the Memory Carrier Assembly Cover
Replacing the Memory Carrier Assembly Cover
To replace the memory carrier assembly cover, follow these steps:
1.
Position the cover onto the opening above the memory carrier assembly.
2.
Slide the cover toward the right side of the server until it is flush with the center chassis wall.
3.
Slide the top cover forward until it is flush with the front of the chassis.
4.
Push the cover release lever down into the latched position (
).
5.
Lock the cover release lever. Turn the cam 90 degrees clockwise.
Installing a Hot-Swappable Power Supply
The server can have one or two hot-swappable power supplies. These power supplies are located
at the rear of the server. The supported configuration of the server requires a minimum of one
power supply. You can install or replace a hot-swappable power supply using the procedures in
this section when power is on or off.
CAUTION:
Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions can result in damage to the server.
Installing Additional Components
13
