17
Figure 16 Removing an X712 Bck(pwr)-Frt(prt) HV2 fan tray
Installing/removing power supplies
WARNING!
•
To avoid bodily injury and device damage, strictly follow the procedures in
Figure 17
and
Figure 18
to install
and remove a power supply.
•
Provide a separate circuit breaker for each power supply.
The HPE 5980 48SFP+ 6QSFP28 switch has two power supply slots and comes with one power
supply slot empty and one installed with a filler panel.
You can select power supplies for the switch as required. For information about the available power
supplies, see "
Appendix B FRUs
."
Figure 17 Power supply installation procedure
Figure 18 Power supply removal procedure
Installing a power supply
The installation procedure is the same for the 650W AC power supply and 650W DC power supply.
The following procedure uses the 650W AC power supply as an example.
To install a power supply:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel, if any, from the target power supply slot, as shown in
Figure 19
.
1
1
2
Install the power
supply
Connect the power
cord
Turn on the circuit
breaker
Turn off the circuit
breaker
Disconnect the power
cord
Remove the power
supply
