Display assembly
This section describes removing components that require you to completely remove the display panel. For
more information about removing display components that do not require that you remove the assembly
from the computer, see
Display assembly components (panel, bezel, webcam, microphone) on page 50
.
NOTE:
The display assembly is spared at the subcomponent level only.
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 29
), and then remove the following components:
a.
Hard drive cover (see
Hard drive cover on page 32
)
b.
Hard drive (see
Hard drive/SSD drive on page 33
)
c.
Service cover (see
Service cover on page 38
)
d.
WLAN module (see
WLAN module on page 43
)
e.
WWAN module (see
WWAN module on page 41
)
f.
Fan (see
Fan on page 58
)
g.
Keyboard (see
Keyboard on page 45
)
h.
Base enclosure (see
Base enclosure on page 53
)
Remove the display assembly:
1.
Disconnect the display panel cable (1) from the system board.
2.
Release the display panel cable from the routing channel (2).
3.
Open the computer and position it with the base enclosure on a table and the display hanging down.
Component replacement procedures
67
Содержание EliteBook Folio 9470m
