HP DesignJet T730, Руководство по устранению неисправностей

Страница: 28 / 57

Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration.
Table A-1 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the ROM, and
make changes to certain plug and play settings under Windows.
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears after a
power cycle or reboot. If the user does not enter the correct power-on password, the unit will not boot.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
●
Stringent Password – When set, enables a mode in which there is no physical bypass of the
password function. If enabled, removing the password jumper will be ignored.
● Password Prompt on F9 & F12 – Default is enabled.
●
Setup Browse Mode – Allows viewing, but not changing, the F10 Setup Options without entering
setup password). Default is enabled.
Device Security Allows you to set Device Available/Device Hidden (default is ‘Device Available’) for:
● Embedded Security Device
● System audio
● Network controller
● SATA Port 0
USB Security Allows you to set Enabled/Disabled (default is enabled) for:
●
Front USB Ports
◦ USB Port 4
◦
USB Port 5
◦ USB Port 10
◦
USB Port 11
● Rear USB Ports
◦
USB Port 0
◦ USB Port 1
◦
USB Port 2
◦ USB Port 3
●
Accessory USB Ports
◦ USB Port 12
Slot Security Allows you to disable the PCI Express slot and Mini Card Slot. Default is enabled.
● PCI Express x8 Slot 1
● M.2 PCIe x1
Network Boot Enables/disables the computer’s ability to boot from an operating system installed on a network server.
(Feature available on NIC models only; the network controller must be either a PCI expansion card or
embedded on the system board.) Default is enabled.
22 Appendix A Computer Setup (F10) Utility, BIOS Settings