HP DesignJet T730, Руководство по устранению неисправностей

Страница: 19 / 57

13. Press the latch down and move it to the right until it clicks into place (2) to secure the PCIe card.
14. Replace and latch the access panel, and then reinstall the rear I/O panel. See Removing and replacing
the access panel on page 4 .
15. Replace the thin client stand.
16. Reconnect the AC power cord and turn on the thin client.
17. Lock any security devices that were disengaged when the thin client access panel was removed.
Installing an internal USB flash drive
There is one USB 3.0 flash drive port on the system board.
To install a USB flash drive:
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external devices.
4. Disconnect the AC power cord from the AC outlet, and disconnect any external devices.
5. Remove the stand from the thin client.
6. Lay the unit flat on a stable surface with the right side up.
7. Remove the thin client access panel. See Removing and replacing the access panel on page 4 .
WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system components
to cool before you touch them.
8. Locate the USB flash drive port on the system board.
Installing an internal USB flash drive 13