Chapter 5 Input/Output Interfaces
5.4 SERIAL
INTERFACE
All models include at least one RS-232-C type serial interface to transmit and receive
asynchronous serial data with external devices. The serial interface function is provided by the
LPC47B367 I/O controller component that includes two NS16C550-compatible UARTs.
The UART supports the standard baud rates up through 115200, and also special high speed rates
of 239400 and 460800 baud. The baud rate of the UART is typically set to match the capability of
the connected device. While most baud rates may be set at runtime,
baud rates 230400 and
460800 must be set during the configuration phase.
5.4.1 SERIAL CONNECTOR
The serial interface uses a DB-9 connector as shown in the following figure with the pinout listed
in Table 5-5.
Figure 5-3.
Serial Interface Connector (Male DB-9 as viewed from rear of chassis)
Table 5–7.
DB-9 Serial Connector Pinout
Table 5-7.
DB-9 Serial Connector Pinout
Pin
Signal
Description Pin
Signal
Description
1
CD
Carrier Detect
6
DSR
Data Set Ready
2
RX Data
Receive Data
7
RTS
Request To Send
3
TX Data
Transmit Data
8
CTS
Clear To Send
4
DTR
Data Terminal Ready
9
RI
Ring Indicator
5 GND
Ground
-- --
--
The standard RS-232-C limitation of 50 feet (or less) of cable between the DTE (computer) and
DCE (modem) should be followed to minimize transmission errors. Higher baud rates may require
shorter cables.
5-8
Compaq D315 and hp d325 Personal Computers
Featuring the AMD Athlon XP Processor
Second Edition – April 2003