Flash drive
Description
Spare part number
1-GB flash drive (includes flash drive bracket)
465619-001
Before removing the flash drive, follow these steps:
1
.
Shut down the computer. If you are unsure whether the computer is off, turn the computer on, and then
shut it down through the operating system.
2
.
Disconnect all external devices connected to the computer.
3
.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4
.
Remove the battery (see
Battery on page 29
).
Remove the flash drive:
1
.
Position the computer with the front toward you.
2
.
Loosen the two Phillips PM2.0×6.0 captive screws
(1)
that secure the flash drive bay cover to the
computer.
3
.
Lift the right side of the flash drive bay cover
(2)
, swing it to left, and remove the cover. The flash
drive bay cover is included in the Plastics Kit, spare part number 417527-001.
4
.
Grasp the Mylar tab
(1)
on the flash drive and pull the module
(2)
to the left to disconnect it from
the system board.
30 Chapter
4
Removal and replacement procedures
Содержание Compaq 6720t
