HP AlphaServer ES47, Справочное руководство CLI

Страница: 2 / 152

October 2003
© 2003 Hewlett-Packard Company.
HP shall not be liable for technical or editorial errors or omissions contained herein. The information in this document
is provided “as is” without warranty of any kind and is subject to change without notice. The warranties for HP
products are set forth in the express limited warranty statements accompanying such products. Nothing herein should
be construed as constituting an additional warranty.
Regulatory Notices for Series ET2003
FCC Notice
Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established Radio Frequency
(RF) emission limits to provide an interference-free radio frequency spectrum. Many electronic devices, including
computers, generate RF energy incidental to their intended function and are, therefore, covered by these rules. These
rules place computers and related peripheral devices into two classes, A and B, depending upon their intended
installation. Class A devices are those that may reasonably be expected to be installed in a business or commercial
environment. Class B devices are those that may reasonably be expected to be installed in a residential environment
(i.e., personal computers). The FCC requires devices in both classes to bear a label indicating the interference potential
of the device as well as additional operating instructions for the user. The rating label on the device shows which class
(A or B) the equipment falls into. Class B devices have an FCC ID on the label. Class A devices do not have an FCC
ID on the label. Once the class of the device is determined, refer to the following corresponding statement.
Class A Equipment
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at personal expense.
Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by Hewlett-Packard Company may void the user's authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in order to
maintain compliance with FCC rules and regulations.
Declaration of Conformity for products marked with the FCC logo – United States only
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.