Removal and replacement procedures 45
7.
Disconnect the signal cables, remove the four T-15 Torx screws securing the power button/UID board
to the power block, and then remove the power button/UID board.
To replace the component, reverse the removal procedure.
Cable management arm
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
25
).
2.
Disconnect all cables.
3.
Remove all power supplies ("
Power supply
" on page
34
).
4.
Remove the fans ("
Fan
" on page
31
).
5.
Remove all hard drives ("
Hard drive
" on page
27
).
CAUTION:
To avoid data loss, be sure that the drives are labeled and returned to the same bays
they were removed from.
6.
Be sure that the hard drive drawer is closed.
7.
Remove the I/O modules ("
Hot-plug I/O module
" on page
32
).
8.
Remove the power block ("
Power block
" on page
40
).
9.
Remove the hard drive drawer ("
Hard drive drawer
" on page
36
).
Содержание 600 Series
