Removal and replacement procedures 36
Hard drive drawer
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
25
).
2.
Disconnect all cables.
3.
Remove all power supplies ("
Power supply
" on page
34
).
4.
Remove all fan modules ("
Fan
" on page
31
).
5.
Remove all hard drives ("
Hard drive
" on page
27
).
CAUTION:
To avoid data loss, be sure that the drives are labeled and returned to the same bays
they were removed from.
6.
Be sure the hard drive drawer is closed completely.
7.
Remove all I/O modules ("
Hot-plug I/O module
" on page
32
).
8.
Pull down the handle on the front of the drawer, but do not extend the drawer.
9.
Push up and hold the two release mechanisms on the I/O bays, and then push the drawer forward
about 15 cm (6 in).
WARNING:
TIP HAZARD! To reduce the risk of personal injury or damage to the equipment, do
not extend the hard drive drawers beyond the supporting surface when the unit is not installed in
a rack.
WARNING:
To reduce the risk of personal injury or damage to the equipment, ensure that only
one hard drive drawer is extended at a time.
WARNING:
To reduce the risk of electric shock or damage to the equipment:
•
Never reach inside the chassis while the system is powered up.
•
Perform service on system components only as instructed in the user documentation.
10.
Remove the power block ("
Power block
" on page
40
).
Содержание 600 Series
