9
Figure 10
T-rail holder
(1) T-rail clip
(2) M4 screw nut
(3) Clip holder
(4) T-rail holder
(5) M3 screw nut
(6) M4 × 5 screw
(7) M3 × 8 screw
(8) Mounting hook
To mount the AP to a ceiling T-rail:
1.
Loosen the two M3 × 8 screws on each clip holder. Do not remove the screws.
2.
Adjust the T-rail clips to make the T-rail holder wider than the T-rail. See callout 1 in
Figure 11
. Then
lock the T-rail with the T-rail holder according to the arrow indicated in callout 2 in
Figure 11
.
Figure 11
Attaching the T-rail holder to the T-rail
3.
Tighten the four M3 × 8 screws on the two clip holders.
4.
Verify that the T-rail holder is attached to the T-rail.
5.
Hook the mounting clip (see callout 3 in
Figure 12
) of the wall-mounting bracket to the mounting
hook (see callout 2 in
Figure 12
) of the T-rail holder.
6.
Insert the two M4 × 5 screws (see callout 1 in
Figure 12
) through the two 5 mm (0.20 in) diameter
holes on the wall-mounting bracket according to the dashed line shown in
Figure 12
. Attach the
screws to the T-rail holder.
7.
Verify that the wall-mounting bracket is attached to the T-rail.
8.
Connect the AP to the network by using an Ethernet cable.
9.
Install the AP to the wall-mounting bracket. For more information, see "
Mounting the AP on a wall
."
1
2
3
4
5
6
7
8
1
2
