Weight
Before removing the weight, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 49
), and then remove the following components:
●
Service door (see
Service door on page 55
)
●
WLAN module (see
WLAN module on page 58
)
●
Hard drive (see
Hard drive on page 79
)
●
Top cover (see
Top cover/keyboard on page 61
)
●
USB board (see
USB board on page 78
)
●
Display assembly (see
Display assembly on page 70
)
●
System board (see
System board on page 83
)
Remove the weight:
1.
Remove the two Phillips PM2.5×6.5 screws
(1)
that secure the weight to the computer.
2.
Remove the weight from the computer
(2)
.
Reverse this procedure to install the weight.
106 Chapter 4 Removal and replacement procedures
Содержание 15 TouchSmart
