HP Autozubehor 20360, Руководство пользователя

Страница: 12 / 41

4
5. MAINTENANCE
WARNING! Make sure battery is removed before carrying out any maintenance.
5.1. Always store the polisher on its side so that the foam pad does not become compressed and/or distorted.
5.2. Remove bonnet when not in use to allow foam pad to dry out.
5.3. Clean the bonnet regularly by hand washing with soap and water.
DO NOT immerse the foam pad in water. Washing the bonnet is sufficient.
5.4. To remove the foam pad, proceed as follows:
5.4.1. Remove the bonnet.
5.4.2. Insert a rod (cross headed screwdriver or similar) into the hole in the side of the pad mounting, see fig.1.
5.4.3. Rotate the pad until the rod contacts the counter-weight.
5.4.4. Hold the pad with one hand.
5.4.5. Undo the motor shaft using a slotted screwdriver. It has a reversed thread, turn it clockwise to undo it and anti-clockwise to tighten it, see fig.2.
Fit a new pad, assembly is reverse of the above.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
WARNING!
–
Risk of Hand Arm Vibration Injury
This tool may cause Hand Arm Vibration Syndrome if its use is not managed adequately.
This tool is subject to the vibration testing section of the Machinery Directive 2006/42/EC.
This tool is to be operated in accordance with these instructions.
Measured vibration emission value (a): 3.325 m/s
²
Uncertainty value (k): 1.5 m/s
²
Please note that the application of the tool to a sole specialist task may produce a different average vibration emission. We recommend that a
Fig.1
Fig.2
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable) into
approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU directive on
Waste electrical and electronic equipment (WEEE). When the product is no longer required, it must be disposed of in an
environmentally protective way. Contact your local solid waste authority for recycling information.
nder the Waste Batteries and Accumulators egulations 2009, Jack ealey td are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance
scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.