HOZAN C-700-13, Инструкция по эксплуатации

Страница: 8 / 8

４ ４ ４ ４
15.01
Head adjusting
1 - 2 - 12 Saiwaicho, Naniwa - ku, Osaka 556 - 0021, Japan
Tel : 81-6-6567-3113 F a x : 81 - 6 - 6562 - 0024
Head maintenance
Lubricate the roller with cutting oil each every time.
Cutting scraps may remain on the roller grooves. Clean the rollers with a brush
periodically to keep cutting performance.
If the roller set nut become loose, turn them softly. Even they are loose, threading
can be performed without hindrance, but it could cause loss of set nuts. If an
adjustable wrench or open wrench is used, it could cause a damage of roller shaft
due to over
-
tightening.
The head is a consumable part. When the roller
wear out, replace the whole head assembly.
Head set screw is a hexagonal socket set screw.
Turn with a 2.5mm hex key.
When installing a new head, engage the tip of the
head set screw with the cavity on the shaft to
prevent slipping.
Roller set nut
Head set screw
●
●
●
●
●
C - 706 replacement head
For # 14 /# 15 , stainless steel/steel spokes
Replacement head
C - 707 - 13 replacement head
For # 13 , stainless steel/steel spokes
Option
If it is in conditions described below, adjust the head properly turning the adjust nut.
●
When the spoke does not enter into the head
●
When the completed thread’s diameter is too small
(A nipple does not go through the thread smoothly or goes hardly)
First, actually work to comprehend the present situation.
Note that the spoke becomes short by repeated adjustment.
Work again employing a spoke which has a renewed section,
and check the situation.
Repeat procedures 2 and 3 . Adjustment is completed for that the nipple goes through
the thread smoothly.
●
●
Adjust nut
27 mm
wrench
22 mm
wrench
Use 22 mm and 27 mm wrenches.
Turn the adjust nut with the 27 mm wrench, while holding
the head with the 22 mm wrench.
Turn the adjust nut little by little since turning it only 5 to 10
degrees causes a large alteration.
Loosen the adjust nut when the spoke does not enter
into the head.
Tighten the adjust nut when the completed thread’s
diameter is too small.
１ １ １ １
２ ２ ２ ２
３
３ ３
３
４ ４ ４ ４