HOZAN C-421, Инструкция по эксплуатации

Страница: 7 / 8

Replacing die
１
Using a 4mm hex key, unscrew the die guard set screws to remove the die guard.
２
Using a 13 mm wrench or an adjustable wrench, unscrew the die set bolt and the
die
adjust bolt to remove the die.
５
Replace the die guard.
・
Make the die adjust bolt and the die set bolt
aim each prescribed place. Do not secure
both the bolt excessively tight. This could
break the die.
・ Be sure to place the die with the size
stamped face upward. Otherwise, you cannot
adjust the die opening, cannot set the die and
cannot start to make a thread.
Typically the work piece is inserted into the
die from the size-stamped face. However,
you should insert the work piece into the
C-432 from the opposite side of the size
stamped face.
 Caution
３
Place the new die in the body, with the size-
stamped face upward and so that the die set
bolt is opposite to the cavity of the die and the
die adjust bolt is opposite to the slit in the die.
３
Replacement die
・ C-422 For BC1
×
24 (Standard size)
Regarding die
We have installed the die for BC1
×
24 fork in the C-421. You cannot use the C-421 even if
installing a die other than this size, since this tool has only just BC1
×
24 sized hole on its
bottom. When the die wears, replace it with a new genuine die.
Die adjust bolt
To fork
Die set bolt
Firmly tighten the die adjust bolt and secure the die with the die set bolt.
４
When starting the threading process, first try tightening the die adjust bolt very firm-
ly (making the slit of the die comparatively wide). Using the tighter die initially
could over-thread the fork.

Caution