LED ASSEMBLY
BACKPLATE
FIG.1
MOUNTING:
The back plate has a cast-in drill and knock-out
template to match any standard recessed junction
box, three 5/16” knockouts for mounting holes A and
three 1/2” NPS tapped holes D for surface conduit or
photocontrol unit.
A – 5/16” dia. Knockouts
B – 9/16” dia. Knockouts
C – Knockouts for #10 screw
D – 1/2” NPS tapped holes.
Drill
Wire Strippers5/16"
Drill bit
Wire Cutters
1/4" Bit Driver
Assorted driver bits
Tools Required:
1. Open the fixure by loosening the two (2)
tamper-proof screws on the side of the housing.
2. Disconnect the LED module power leads from
the LED driver and remove the LED assembly. Do
not drop or mishandle the LED assembly.
3. Prepare the back plate for mounting by drilling
or knocking out the appropriate holes. Item A on
Fig. 1.
4. Line up the back plate in the desired location
and mount securely. LED driver assembly may
need to be removed.
5. Apply silicone caulking around the back plate
between the mounting surface for a
weather-tight seal.
6. Reattach the LED driver assebly to the back plate.
7. Wire the fixture leads to the supply leads per Fig. 2 below.
** For EM: Please refer to the wiring diagram on Fig. 3
below. Supply power to the fixture. Connect the battery
plug to the EM. Turn off the wall switch to the fixture.
Installation Guide
8. Reattach the LED module power leads to the driver
and replace the LED assembly using the provided
tamper-proof screws.
9. For EM fixture, press the test button on the side of
the fixture to make sure EM is functioning properly.
Medium Wall Pack, Gen-2
