1
2320961
Tripod Floor Clock Quartz Movement
And Pendulum Instruction
CLOCK SET UP INSTRUCTIONS
1. Move the clock close to its final location. Make sure the clock is positioned firmly on the floor.
WARNING:
ENSURE CLOCK IS POSITIONED SQUARE AND FIRM ON THE FLOOR SO THAT IT WILL
NOT FALL OVER.
2. Access the clock’s quartz movement through the back access panel. (See Figure 1) Loosen
the knob by turning counter-clock wise. Be sure to hold the back panel in place as the knob
is loosened. Gently pull on back access panel to release from magnetic catches. Replace
this panel after set up is complete, and tighten the knob to hold it in position.
WARNING:
KEEP PLASTIC BAGS AND SMALL PARTS AWAY FROM CHILDREN.
QUARTZ MOVEMENT INSTRUCTIONS
SETTING THE TIME
1. Before inserting the batteries (Figure 2), adjust the time to 5:50 by using the Time Setting knob
(Figure 2) to rotate the hands
CLOCKWISE.
2. Install two “C” size alkaline batteries according to the +/- symbols in the battery holders.
(Figure 2)
Do not install the batteries on the Pendulum Drive motor at this time. (Figure 3)
3. Set the time by using the Time Setting knob (Figure 2) to rotate the hands
CLOCKWISE
. If
setting the time for PM, make sure the hour hand passes through 12 o’clock noon until the
desired time is shown. While setting the time, it is normal to hear sounds from the movement
or speaker. Continue advancing the time until the correct time is shown. Once the time is set,
the melody will adjust to the time selected, however,
it is important that the clock movement
operate for at least one hour for the chime sequence to become fully functional
. The clock
may chime out of sequence during the first hour of operation. The quartz movement is highly
accurate and has been adjusted at the factory for precise time keeping.
SETTING THE MELODY (SEE FIGURE 2)
SELECT: Use the chime SELECT switch to select the chime melody according to the following
settings:
4X4 WESTMINSTER = Westminster melody and Hour Strike on the hour. Additionally ¼ of
the melody at quarter past the hour, ½ the melody at half past the
hour, ¾ of the melody at three-quarters past the hour, and the full
melody on the hour.
4X4 AVE MARIA = Ave Maria melody and Hour Strike on the hour. Additionally ¼ of the
melody at quarter past the hour, ½ the melody at half past the
hour, ¾ of the melody at three-quarters past the hour, and the full
melody on the hour.
WESTMINSTER = Westminster melody and Hour Strike on the hour. No ¼, ½, ¾ melody
during the hour.
BIM BAM =
Bim Bam strike on the hour (i.e. at 1 o’clock, 1 strike of “bim-bam”,
at 2 o’clock then 2 strike of “bim-bam”, etc.) No melody.
VOLUME CONTROL (SEE FIGURE 2)
VOLUME: Turn the Volume Control Knob to adjust the volume.
SOUND: Use the SOUND switch to select the sound options according to the following settings:
PM11:00-AM5:45 NIGHT OFF = turns off the chime melody and strike from 11:00PM to
5:45AM (Automatic Nighttime volume shut-off)
24 Hr ON = the chime melody and strike are always ON
OFF = the chime melody and strike are always OFF
FIGURE 1
QUARTZ MOVEMENT FIGURE 2
SELECTION
SOUND
RESET
VOLUME CONTROL
BATTERY
TIME SETTING
MONITOR
SET
