2
2320961
OTHER FEATURES (SEE FIGURE 2)
MONITOR: Press the MONITOR button to demonstrate the hourly chime melody.
SET:
Advances the hour strike count without advancing the time shown on the clock. Hour strike may not match time shown on clock
after pressing the SET button.
RESET: Resets the next hour strike count to 6:00AM. If after at least one hour, the hour strike count does not match the time:
- set the time to 5:50 by using the Time Setting knob to rotate the hands CLOCKWISE
- press the RESET button
- set the time to the desired time by using the Time Setting knob to rotate the hands CLOCKWISE
(If setting PM time, make sure the hour hand passes through 12 o’clock noon until the desired time
is shown.)
PENDULUM SET-UP
1.
Be sure the pendulum driver is aligned vertically inside the clock. (FIGURE 3 & 4) The pendulum swing will be affected if the driver is not vertical.
2.
To align the driver ,loosen the two mounting screws located at the top. Align the driver vertically and tighten the mounting screws. (FIGURES 5 & 6)
3. Release the Pendulum Guide from the Transport-Locking Pin (Figure 3) by gently pushing it sideways, allowing the guide to hang freely.
4. Hang the pendulum on the pendulum guide. (Figure 7 & 8).
5. The pendulum hook must fit snug on the pendulum guide to prevent erratic pendulum movement. The hook can be crimped with a pliers
if necessary.
6. Install two “D” size alkaline battery for pendulum drive. (Figure 3)
7. Move the pendulum to the far left of center and release. (Figure 9)
8. Let the clock operate a few minutes until the pendulum settles into an even swinging motion.
BATTERY REPLACEMENT
If the clock begins to lose time, chime weakens, or pendulum does not swing, this is the sign of weak or exhausted batteries. Replace with
new alkaline batteries.
PENDULUM DRIVER FIGURE 3
BATTERY
PENDULUM
GUIDE
TRANSPORT LOCKING PIN
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
