430294ENG-Jun02
User Instructions
5
Attention:
·
During summer switch off the following
symbols are not shown and .
·
Blinking symbols or indicate that
the unit is not operating under a normal
program eg. party.
Additional Information
The following additional information can be
obtained by pressing the button (only if the
relevant sensors are fitted):
Default display.
External sensor
temperature.
Flow temperature.
Boiler return
temperature.
Domestic hot water
temperature.
If the calorifier is fitted with a thermostat instead
of a sensor the following will be displayed:
Calorifier on/off.
Default display.
Fault Indications
The RS-30 room station has a comprehensive
fault indication system which has priority over all
other indications and remain active until the fault
is rectified.
Faults concerning the firing unit must be rectified
in accordance with operating manual
instructions.
If any of the following fault displays are shown
(Fault – System Off, Fault – Hot water
temperature, Fault – Boiler temperature, Fault –
Room temperature ) you must notify the heating
engineer.
Automatic Program Selection
In automatic there are three different time
programs to switch between for the heating. As a
general rule these can be used without the need
for adjustment but if individual programs are
required customised cycles can be entered (see
the advanced user section ).
Program 1
Day
Heating on time
Mo – Fr
Sa, Su
6.00 - 8.00
16.00 - 22.00
7.00 - 23.00
2 – Program 2
Day
Heating on time
Mo – Su
6.00 - 22.00
Program 3
Day
Heating on time
Mo – Su
6.00 - 23.00
i
i
i
i
i
i
