Hottek HT-964-200, Руководство пользователя

Страница: 13 / 28

ENG
13
6. 4 Attachment Combs:
3 mm
6 mm
9 mm
12 mm
7. Clipper Oil
8. Cleaning Brush
9. Barber Comb
10. Scissors
11. Hanging loop
Blade Alignment
• Your clippers were carefully examined to unsure that the blades were oiled and
aligned before leaving our factory.
• Blades must be realigned if they have been
removed for cleaning or replacement.
• To realign the blades, simply match the
upper and bottom blades teeth up, point
for point.
• End of top blade teeth should be
approximately 1.2mm back from bottom
blade. Compare your clipper blades
withthe sketch.
• If blade alignment is incorrect, add a few
drops of oil to the blades, turn clipper on
for a few moments, turn off and unplug.
• Loosen screws slightly and adjust. Tighten
screws after blade is aligned.
Blade Oiling
• To maintain your hair clipper in peak condition, the blades should be oiled
using the engine oil.
• Do not use hair oil, grease, oil mixed with kerosene or any solvent.
• The solvent will evaporate and leave a thick oil which may slow down the
blades motion.
Blade Lever (5)
• The blade lever (5) is conveniently located near your thumb (if you’re right-
handed) so it can be easily adjusted while the clipper is in your hand.