Hottek HT-964-200, Руководство пользователя

Страница: 14 / 28

ENG
14
• The blade lever adds versatility to your
clipper by allowing you to gradually
change the closeness of your cut
without an attachment comb.
• When the blade lever is in the
uppermost position, the blades will give
you the closest cut and leave the hair
very short. Pushing the lever downward
gradually increases the cutting length.
• In its lowest position, the blade lever will leave the hair approximately the
same length as 6.1 attachment comb (3mm).
• In its highest position, the blade lever will leave the hair approximately the
same length as 6.4 attachment comb (12mm).
• The blade lever (5) will also extend the use of your blades since a different
cutting edge is used in each setting.
• The blade lever (5) will help to remove hair that has stuck between the
blades.
• To remove stuck hair, move the blade lever (5) from lower to upper position
a couple of times.
• If your hair clipper stops cutting and this does not help, your cutting blades
are dulled. Replace them with new blades.
Warning
• Clean the blades from hair when idle and after each haircut. This will
remove any and all remaining hair.
Before First Use
• Before each use inspect the hair clipper and ensure that it is free from
oil between the cutting blade teeth.
• Switch the hair clipper on to distribute the oil and to make sure it is
running smoothly.
• While using the appliance, untwist the cord from time to time to avoid
tangling.
• Seat a person so that his/her head is at your eyes level. This provides
better control of hair cutting.
• Before cutting always carefully comb hair to ensure that there are no
tangles.
• Place a towel around the neck of a person having the haircut to avoid
the cut hair to fall under the collar.