13
Operations
Operating Instructions
STEP 2:
Fill engine/burner fuel
tanks with fuel. Engine requires
“Ultra Low Sulfur Diesel Fuel”
only”.
WARNING! Never replace
nozzles without engaging the
safety latch on the spray gun
trigger.AVERTISSEMENT: Ne
jamais remplacer les buses sans
d'abord mettre le dispositif de
sécurité sur la détente du
pistolet pulvérisateur.
STEP 3:
Before installing nozzle,
trigger the spray gun to eliminate
trapped air then wait for a steady
flow of water to emerge from the
wand coupler when engine starts.
Run machine allowing water to
flush through the system until clear.
STEP 4:
Read engine operators
manual before starting. Turn the
key to GL (Glow Plug) and wait for
light to go out. Turn the engine
switch to ST (Start)
position.
The quick connect nozzles provide
a wide array of spray widths from 0°
to 40° and are easily accessible
when placed in the convenient
rubber nozzle holder, which is
provided on the front of the
machine.
NOTE: For a more gentle rinse,
select the white 40° or green 25°
nozzle. To scour the surface,
select the yellow 15° or red 0°
nozzle.
Oil Dip
s
tick
Oil Dip
s
tick
Oil Filler Cap
Fuel
Tank
Safety
Latch
Engine
On-Off
Switch
Manual Operator HOTSY 1265SSD/S 9.808-057.0 - A
CAUTION: Read engine manual before starting.
ATTENTION : Lire le manuel du moteur avant de démarrer l'appareil.
STEP 1:
Check engine oil level. Oil level should be between the lines on the dipstick. (Refer to the engine's
operating manual included with machine.) We recommend that the oil be changed after the first 5 hours of use, then
once every 50 hours.
NOTE:
Improper oil levels will cause low oil sensor to shut off engine.
IMPORTANT! Do not
run engine with high or low oil levels as this will cause engine damage.
