Hotronix FUSION IQ, Руководство оператора

Страница: 5 / 20

5 WWW.HOTRONIX.COM
Machine View Operating Instructions
Insert power cord into IEC inlet located on the side of press (1.1).
Connect the power cord into a properly grounded electrical outlet
with a sufficient amperage rating.
Voltage
240 volt requires a full 10-amp
grounded circuit
Extension Cords
If used, extension cords should be as short as possible and
not less than 12 gauge. Heavy duty cords are recommended.
Circuits
Circuits that have less than 15 amps, or have other high demand
equipment or appliances (especially more than one heat press)
plugged in, should not be used.
Note: If supply cord is damaged, it must be replaced by the manufacturer,
its service agent, or a similarly qualified person to avoid hazard. Use SJT
type rated 300 V cord for replacement.
Connecting the System
To start up your heat press:
Flip the power switch ON (2.1). A splash screen displaying the Hotronix
®
logo and current software version is shown for several seconds.
To turn your heat press off, flip the power switch OFF.
To place your heat press into Standby Mode, touch and release the
Power icon on the Home Screen (3.2). In Standby Mode,
the heater turns off while the Touch Screen remains on, displaying an
orange background as a warning if the platen is still hot (above 100°F / 38°C).
NOTE: Standby Mode must be used for the Auto On feature to function
(10.1). The Auto On feature will not work if the power switch (2.1) is in
the OFF position.
To start up your heat press while in Standby Mode,
touch and release the Home icon on the Standby Screen.
Start Up/Shut Down
1.1
1.2
2.1