S E R V I C E H O T L I N E : 8 0 0 . 7 2 7 . 8 5 2 0 H O T R O N I X . C O M
HOTRONIX
®
AIR SWINGER
HOTRONIX
®
AIR SWINGER
PAGE 11
Pressing
OPTIONAL GARMENT PRE-PRESS TACK MODE
Position the garment and
press the Tack Button
located on top of the
Control Housing.
Gently swing the top platen in a smooth continuous motion until it
lines up with the lower platen. With both hands, press the Print
Buttons located on each side of the press. The top platen will lower
to the print position and remain there until you release the buttons.
CAUTION:
Once the Print Buttons are released, the top platen will
return to the UP position.
To exit the Tack Mode simply press the Tack Button.
PREPARE TO PRINT
When the targeted press temperature is reached, the display will prompt you with the message
“READY TO PRINT”. This display will flash alternately with the “Temperature/Time” display.
Position garment and application. Gently swing the top platen in a smooth continuous motion, until it lines up
with the lower platen. With both hands, press the Print Buttons located on the side of the press. The heat
platen will lower to the print position and remain lowered for the number of seconds indicated by the timer.
CAUTION:
When the print cycle is complete, the heat platen will return to the UP position and audibly signal.
Gently swing the top platen to the side and proceed according to the application’s instructions.
7.
8.
Alternating Displays
The display will then
show this message
Example: 005, 004, 003, 002, 001
