Hotpoint GW32, Инструкция по эксплуатации

Страница: 18 / 24

Installation Instructions
18
Prior to installation, ensure that the local distributions (nature of the gas
and gas pressure) and the adjustment conditions are compatible. The
adjustment conditions for this appliance are stated on the data badge
which is fitted on the rear panel.
This appliance is not designed to be connected to a combustion
products evacuation device. It must be installed and connected in
accordance with current installation regulations. Particular attention
should be given to the relevant requirements regarding ventilation.
MODEL NUMBERS GW32
Category
I
2H
(
G.B. IE)
These models are set to burn NATURAL GAS (G20) at 20 mbar ONLY and
cannot be used on any other gas.
MODEL NUMBERS GWL32
Category I
3
+ (G.B. IE)
These models are set to burn PROPANE GAS (G31) at 37 mbar and
BUTANE GAS (G30) at 28 - 30 mbar and cannot be used on any other gas
It is the law that all gas appliances are installed by competent persons in
accordance with the current edition of the above regulations. It is in your
interest and that of safety to ensure compliance with the law.
In the UK, CORGI registered installers work to safe standards of practice.
The cooker must also be installed in accordance with BS 6172.
Failure to install the cooker correctly could invalidate the warranty
liability claims and could lead to prosecution.
The cooker may be located in a kitchen, kitchen/diner or a bed-sitting
room, but not in a room containing a bath or shower. The cooker must
not be installed in a bed-sitting room of less than 20m
3 .
L.P.G. models must not be installed in a room or internal space below
ground level e.g. in a basement.
The room containing the cooker should have an air supply in accordance
with BS 5440: Part 2
The room must have an opening window or equivalent; some rooms
may also require a permanent vent. If the room has a volume between 5
and 10m
3 , it will require an air vent of 50cm 2 effective area unless it has a
door which opens directly to outside. If the room has a volume of less
than 5m
3 , it will require an air vent of 100cm 2 effective area. If there are
other fuel burning appliances in the same room, BS 5440: Part 2 should
be consulted to determine air vent requirements.
Gas Safety
(Installation & Use)
Regulations
Location
Provision for
Ventilation