WASH CYCLES
Follow the instructions on the symbols of the garment’s wash
care label. The value indicated in the symbol is the maximum
recommended temperature for washing the garment.
Anti-Stain
this programme is suitable to heavily-soiled garments with resistant
colours. It ensures a washing class that is higher than the standard class
(A class). When running the programme, do not mix garments of different
colours. We recommend the use of powder detergent. Pre-treatment with
special additives is recommended if there are obstinate stains.
If the drying function is selected, a drying cycle automatically activates at
the end of the wash cycle that resembles open-air drying, with the added
advantages of preserving garments from yellowing due to sunlight
exposure and preventing loss of whiteness caused by the possible
presence of dust in the air. Drying cycles can only be selected on a level
basis. Dryness level “
” recommended.
Anti-Stain Quick
this programme is ideal for washing the most difficult daily stains in 1
hour. It is ideal for mixed fabrics and coloured garments, caring for your
clothes as it washes.
If the drying function is selected, a drying cycle automatically activates at
the end of the wash cycle that resembles open-air drying, with the added
advantages of preserving garments from yellowing due to sunlight
exposure and preventing loss of whiteness caused by the possible
presence of dust in the air. Drying cycles can only be selected on a level
basis. Dryness level “
” recommended.
Whites
for heavily soiled whites and resistant colours.
Eco Cotton
Suitable for washing moderately soiled cotton garments. At 40°C and
60°C it is the standard cycle for washing cotton garments, and is the most
efficient in terms of combined water and electricity consumption.
Synthetics
Suitable for washing moderately soiled garments made of synthetic fibres
(e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton fibres.
Anti Allergy
Suitable for removing major allergens such as pollen, mites and cat or
dog hair.
Wool
-
Woolmark Apparel Care - Green:
the wool wash cycle of this machine has been approved by The
Woolmark Company for the washing of wool garments labelled as “hand
wash” provided that the products are washed according to the
instructions on the garment label and those issued by the manufacturer
of this washer-dryer (M1318)
Delicates
use programme to wash very delicate garments with decorative features, such
as diamantes and sequins.
We recommend turning the garments inside out before washing and
placing small items into the special bag for washing delicates.
When selecting an exclusively time-based drying function, a drying cycle
is performed at the end of the wash cycle that is particularly delicate,
thanks to light handling and appropriate temperature control of the
water jet.
The recommended durations are:
1 kg of synthetic garments --> 150 min
1 kg of synthetic and cotton garments --> 180 min
1 kg of cotton garments --> 180 min
The degree of dryness depends on the load and fabric composition.
Fast Wash 30’
For washing lightly soiled garments in a short time. Not suitable for wool,
silk and garments to be washed by hand.
Wash & Dry 45’
select programme for washing and drying lightly soiled garments (Cotton
and Synthetics) in a short time. This cycle may be used to wash and dry a
laundry load of up to 1 kg in just 45 minutes. To achieve optimum results,
use liquid detergent and pre-treat cuffs, collars and stains.
Drying Cottons
To dry cotton garments.
Drying Synthetics
To dry synthetics garments.
Drying Wool
To dry wool garments.
Rinse
Designed for rinsing and spinning.
Spin + Pump out
Designed for spinning and draining the water.
INDICATOR LIGHTS
The indicator lights provide important information. This is what they can tell you:
Wash cycle phase indicator lights
Once the desired wash cycle has been selected and has begun, the
indicator lights switch on one by one to indicate which phase of the cycle
is currently in progress.
Note:
during the “Drain” phase, the indicator light corresponding to the
“Spin” cycle phase will illuminate.
Door locked indicator light
If this indicator light is on, the appliance door is locked to prevent it from
being opened accidentally; to avoid any damage, wait for the indicator
light to switch off before you open the appliance door (wait
approximately 3 minutes).
! If the START/PAUSE
indicator light (orange) flashes rapidly at the
same time as the function indicator light, this indicates a problem has
occurred (see “Troubleshooting”).
FIRST-TIME USE
Once the appliance has been installed, and before it is used for the first
time, run a wash cycle with detergent and no laundry, by setting the
“Auto-Clean” cycle.
DAILY USE
Prepare the laundry by following the suggestions appearing under the
“TIPS AND SUGGESTIONS” section.
- Press the ON/OFF button ; all the indicator lights will turn on for a few
seconds, then only the indicator lights relative to the selected programme
settings will remain lit and the START/PAUSE
indicator light will flash.
- Open the door. Load the laundry while making sure not to exceed the
maximum load quantity indicated in the wash cycle table.
- Pull out the detergent dispenser drawer and pour the detergent into the
relevant compartments, as described in the “DETERGENT DISPENSER
DRAWER” section.
- Close the door.
- Select the desired wash cycle.
- Set the washing temperature.
- Select the desired options.
- Press the START/PAUSE
button to start the wash cycle; the relative
indicator light will light up steady green and the door will lock (the
indicator light will switch on).
PAUSING A CYCLE
To pause the wash cycle, press the START/PAUSE
button again; the
indicator light will flash amber. To start the wash cycle from the point at
which it was interrupted, press the START/PAUSE
button again.
OPENING THE DOOR, IF NECESSARY
Once a cycle starts, the indicator light turns on to signal that the door
cannot be opened. While a wash cycle is running, the door remains
locked. To open the door while a cycle is under way, for example, to add
or remove garments, press the START/PAUSE
button to pause the
cycle; the indicator light will flash amber. If the indicator light is not lit,
the door may be opened (wait approximately 3 minutes). Press the START/
PAUSE
button again to continue the cycle.
CHANGING A RUNNING WASH CYCLE
To change a wash cycle while it is in progress, pause the washer-dryer
using the START/PAUSE
button (the relative indicator light will flash
amber), then select the desired cycle and press the START/PAUSE
button again.
! To cancel a cycle that has already begun, press and hold the ON/OFF
button. The cycle will be stopped and the machine will switch off.
AT THE END OF THE WASH CYCLE
At the end of the wash cycle the
indicator light will switch on; when
the
indicator light switches off, the door may be opened (wait
approximately 3 minutes). Open the door, unload the laundry and switch
off the machine. If you do not press ON/OFF button, the washer-dryer
will switch off automatically after about a half of an hour.
OPTIONS
- If the selected function is not compatible with the programmed wash
cycle, the corresponding indicator light will flash and a sound alert (3
beeps); the function will not be activated.
- If a function which is incompatible with another function selected
previously, only the most recent selection will remain active.
Wash
Rinse
Spin
Drying
End of wash cycle
Note:
as soon as a drying
level or time period has
been set, this indicator light
illuminates to indicate that
the selected wash cycle will
be followed by a drying
phase.
END
