36
GB
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
• Slight differences in colour on the front of the oven
are due to the different materials used, i.e. glass,
plastic or metal.
• Any shady areas resembling grooves on the oven
door glass are caused by reflections from the
oven light.
• The enamel is branded at very high temperatures.
This process may cause colour variations. This is
normal and will not affect appliance operation in
any way. The thin edges of the sheet metal
cannot be entirely enamelled and may therefore
appear to be unfinished. This will not affect the
rust protection.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
• We recommend that detergents are not sprayed
directly onto the control panel, but that a sponge
is used instead.
!
Never use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
!
The door of
LED INSIDE
models cannot be
removed.
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully (
see diagram
).
2. Use a screwdriver to lift up and turn the small
levers
F
located on the two hinges (
see diagram
).
3. Grip the door on the two
outer sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its slot (
see diagram
).
To replace the door, reverse
this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Service Centre (
see Assistance
). We recommend
that the oven is not used until the seals have been
replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the
light bulb and
replace it with a
similar one:
halogen lamp
voltage 230 V,
wattage 25 W,
cap G 9.
3. Replace the
glass cover (
see
diagram
).
!
Do not touch the light bulb directly with your
hands.
Sliding rack kit assembly
To assemble the
sliding racks:
1. Remove the two
frames, lifting them
away from the spacers
A (
see figure
).
Care and maintenance
Glass cover
Lamp
Lamp Holder
compartment
F
A