20
GB
N
L
2. Install the power supply
cable by loosening the cable
clamp screw and the three
w i r e c o n t a c t s c r e w s
L-N-
.
Connect the wires to the
corresponding terminals:
the Blue wire to the terminal
marked (N), the Brown wire
to the terminal marked (L)
and the Yellow/Green wire
to the terminal marked
(see diagram).
3. Secure the cable by fastening the clamp screw.
4. Close the cover of the terminal board.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the data plate (see table).
The appliance must be directly connected to the mains using
an omnipolar switch with a minimum contact opening of 3
mm installed between the appliance and the mains. The
switch must be suitable for the charge indicated and must
comply with current electrical regulations (the earthing wire
must not be interrupted by the switch). The supply cable
must be positioned so that it does not come into contact
with temperatures higher than 50°C at any point (the back
panel of the oven, for example).
!
The installer must ensure that the correct electrical
connection has been performed and that it is fully compliant
with safety regulations.
Before connecting the appliance to the power supply, make
sure that
• The appliance is earthed and the plug is compliant with
the law.
• The socket can withstand the maximum power of the
appliance, which is indicated on the data plate.
• The voltage is in the range between the values indicated
on the data plate.
• The socket is compatible with the plug of the appliance.
If the socket is incompatible with the plug, ask an
authorised technician to replace it. Do not use extension
cords or multiple sockets.
!
Once the appliance has been installed, the power supply
cable and the electrical socket must be easily accessible.
!
The cable must not be bent or compressed.
!
The cable must be checked regularly and replaced by
authorised technicians only (see Assistance).
!
The manufacturer declines any liability should these
safety measures not be observed.
Dimensions*
(With
glass panel fitted to the
inside of the door)
width
43,5 cm
height
32,4 cm
depth
41,5 cm
Volume*
(With
glass panel fitted to the
inside of the door)
59 lt.
Dimensions
**
(With
glass panel fitted to the
inside of the door)
width
45,5 cm
height
32,4
cm
depth
41,5 cm
Volume
**
(With
glass panel fitted to the
inside of the door)
62 lt.
Electrical
connections
voltage:
220-240V~ 50Hz
(see data plate) maximum power
absorbed 2800 W
ENERGY
LABEL
APPLIANCE SPECIFICATIONS
Dimensions*
width 43,5 cm
height 32,4 cm
depth 40,6 cm
Dimensions**
width 45,5 cm
height 32,4 cm
depth 40,6 cm
Volume*
58 lt.
Volume**
60 lt.
* Only for models with drawn rails.
** Only for models with wire rails.
Directive 2002/40/EC on the label
of electric ovens.
Standard EN 50304
Energy consumption for Natural
convection – heating mode:
Traditional mode
Declared energy consumption for
Forced convection Class –
heating mode: Baking
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EEC dated 12/12/06
(Low Voltage) and subsequent
amendments
- 2004/108/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 2012/19/EC and subsequent
amendments.
1275/2008 standby/off mode.
Содержание FH 89 P IX/HA S
Страница 55: ...55 PT...
Страница 56: ...56 PT 195101920 03 03 2013 XEROX FABRIANO...