17
S
Rear Seal
1.
Remove the drum as in (Q).
2.
Remove the rear seal and clean any remnants of the seal and adhesive from the inner face of
the inner back panel. Fit the new seal using adhesive Part No 981027.
T
Heating Assembly & Thermostats
1.
Remove the right hand side panel as in (F).
2.
Disconnect the wiring to the heater assembly (multi-pin connector).
3.
Remove the bearing cover.
4.
Remove the 8 screws securing the heater assembly to the rear panel.
5.
Remove the 2 screws retaining the element and thermostats to the heater cover.
NOTE -
If the heater assembly has failed under the 12-month guarantee period, the complete
heater assembly should be replaced, and the faulty unit sent back via the normal Q+R
procedure.
If replacing the thermostats both the cycling and one-shot thermostat
MUST
be replaced should
either fail.
NOTE: - When refitting the heater cover, ensure the heater wiring Is not trapped between
the inner and outer rear panels.
U
Rear Bearing
1.
Remove the drive pin.
2.
Using a small electrical screwdriver or similar implement, carefully extract the bearing block from
the bracket on the rear panel.
From Serial Number 51103.0001 a teardrop shaped bearing was used on production.
Dismantling is similar except the bearing is secured to the back panel by a screw.
