and thus, in order to protect it, the intervention of a thermal protection will block the motor
until it will cool down. Once cold, the unit will work again.
• If, after preparing a "hot" recipe, you want to switch to a "cold" recipe, in order to speed up
the cooling times it is recommended to let the appliance work at speed 10 for about 2
minutes.
• Do not lift or move the unit by grasping the handle.
IN THE CASE....
The device does not turn on:
- Check that the plug is inserted into the socket.
- Check that the lid is closed completely, and there is no blinking icon on the display.
The unit will stop automatically:
- Verify that you do not have introduced excessive amounts compared to what the
machine can accept and has not, thus leading to overheating as described above. (see section
"thermostat"). In this case will be displayed "Er: 01". Will be enough to put the machine in
stand-by and wait until the engine cools down, because the apparatus is again ready for use.
The unit does not start and appears on the display "Er: 02":
- It means that the unit has been exposed to an external temperature too low (for ex. in case
of transport, during the winter). Will be sufficient to place the device in a normally heated and
wait a few minutes.
The unit does not start (or stop responding during processing) and appears on the
display "Er: 03". Means that:
1) were introduced into the glass excessive amounts of ingredients. Will be enough to empty a
little the glass.
2) It was set a speed inappropriate to the type of processing. Will be sufficient to correct the
speed by pressing the button first. ... And follow the procedures described in paragraph "2 -
Correction of the data set.
The unit heats abnormally (i.e. too much or too little):
- Verify that the heating element is not dirty (in this case, see "Cleaning the Unit")
• The display lights up the icon of the "key": the unit should be taken into a service centre.
RECYCLING AND WASTE DISPOSAL
When the device stops working and must be scrapped, you must ensure that its disposal will
cause the least environmental damage possible, in accordance with the following European
legislation 2002/96/EC:
1 - When a product is given the symbol of a garbage crossed out, it means that the product is
covered by the European Directive 2002/96/CE.
2 - All electrical and electronic products should be disposed separately from the municipal
waste collection, and being collected within specific plants designated by the government or
local authorities.
3 - The proper disposal of obsolete equipment helps to prevent possible negative
consequences on human health and the environment.
4 - For more detailed information on the disposal of obsolete equipment, please contact the
municipality, the waste disposal service or the shop where you purchased the product.
